can't resume recovery

[rzmuda]

I don't say any way to open the map file and restart the process.

Is there any way to do that? I am using ddr rescue gui.



note from developer of dir rescue

When used from the command line, you just press Control-C and run again
the same command with the same mapfile. It will show the amount of data
already rescued and continue from there. I don't know how DDRescue-GUI
allows you to select a mapfile, etc. You'll need to read the
documentation of DDRescue-GUI.


How can I do this using your gui program?

the answer in the forum does work down below as it says you can select it but when you do that it over rides it.
File many doesn't have anything in out like an pen as expected.

[hamishmb]

Yes, on macOS I can't silence the warning about overwriting the recovery, but it will work just fine. You can always make a copy of the map file if you are concerned.

[cathiss20]

I don't say any way to open the map file and restart the process.

Is there any way to do that? I am using ddr rescue gui.



note from developer of dir rescue

When used from the command line, you just press Control-C and run again
the same command with the same mapfile. It will show the amount of data
already rescued and continue from there http://www.rachat-de-credit-simulation. ... nt-de-pret . I don't know how DDRescue-GUI
allows you to select a mapfile, etc. You'll need to read the
documentation of DDRescue-GUI.


How can I do this using your gui program?

the answer in the forum does work down below as it says you can select it but when you do that it over rides it.
File many doesn't have anything in out like an pen as expected.

Peut être est ce que à cause de la compatibilité avec ton navigateur, je ne sais pas.

[Brignac55]

I think it may be because of the compatibility with your browser, I do not know.